A company has an Aruba solution. A network administrator wants to prevent wireless users from accessing shopping web sites with a bad reputation.
What should the administrator set up to deny such traffic?
A.
an AppRF engine
B.
application filters in the Traffic Analysis dashboard
C.
firewall access control rules that specify HTTP and HTTPS
services
D.
firewall application rules
firewall application rules
What is a reason for a company to choose to deploy an Aruba 7024 Mobility
Controller (MC) rather than an Aruba 7010 MC?
A.
to support 802.11ac Aps rather than only 802.11n APs
B.
to support more wireless users
C.
to support more POE devices directly connected to the MC
D.
to support a faster firewall throughput rate
to support more POE devices directly connected to the MC
What is a key difference between an Aruba Air Monitor (AM) and an Aruba Spectrum
Analyzer (SA)?
A.
An AM detects threats such as rogue APs, while an SA analyzes RF conditions.
B.
An AM detects rogue APs and provides data services to clients, while an SA only detects rogue APs.
C.
An AM scans on only one 802.11 frequency band, while an SA scans on both 802.11 frequency bands.
D.
An AM both detects wireless intrusion attempts and mitigates them, while an SA only
An AM detects threats such as rogue APs, while an SA analyzes RF conditions.
An AP operates on channel 6. Which device causes the most significant and
consistent interference with the signal?
A.
cellular phone
B.
weather radar
C.
wireless security camera operating on channel 8
D.
DAP operating on channel 11
wireless security camera operating on channel 8
Refer to the exhibits.
A network administrator configures a guest WLAN on an Aruba Mobility Master
(MM)-based solution. The exhibits show some of the settings for this WLAN.
Which settings must the administrator configure on each Mobility Controller (MC) at
the device level for this configuration to function properly?
A.
an IPsec preshared key
B.
CPSec certificates
C.
a portal page
D.
VLAN 99 IP settings
VLAN 99 IP settings
What is an advantage for a network administrator to use AirWave over a Mobility Master
(MM)?
A.
ability to gather and analyze historical user data, and monitor client association and network usage trends
B.
scans wireless client settings and brings those settings in compliance with corporate
security policies.
C.
ability to monitor and manage a Mobility Controller (MC) to configure the
WLAN
D.
provides realtime firewall hits for client network troubleshooting
ability to gather and analyze historical user data, and monitor client association and network usage trends
Which deployment option for Aruba Controllers is new to ArubaOS 8?
A.
deployment as virtual appliances
B.
deployment in standalone mode
C.
deployment in master-local mode
D.
deployment as branch office controller
deployment as virtual appliances
A company has a single Aruba Mobility Master (MM)-based solution with two Mobility
Controllers (MCs). Network administrators want APs in building 1 to support a WLAN
but do not want APs in building 2 to support the WLAN.
How can administrator ensure that they can enforce this rule as they set up the WLAN in
the Mobility Master (MM) Interface?
A.
Place APs in different buildings in different AP Groups.
B.
Assign APs in different buildings to different MM nodes.
C.
Configure APs in different buildings to use different frequency bands.
D.
Assign different radio profiles to APs in different buildings.
Place APs in different buildings in different AP Groups.
A network administrator configures this policy:
Users to which this policy applies are unable to receive IP addresses with DHCP.
How should the administrator fix the issue?
A.
Change user to any in the user any svc-dhcp permit rule.
B.
Move the user any svc-dhcp permit rule to the bottom of the list.
C.
Remove the deny rule from the policy.
D.
Use the correct service alias in the user any svc-dhcp permit rule.
Use the correct service alias in the user any svc-dhcp permit rule.
A network administrator reduces an AP radio transmit power from 18 dBm to 15 dBm. This
is a loss of 3 dBms.
What is the current power as a percentage of the original power?
A.
10%
B.
33%
C.
50%
D.
83%
50%