350-601 Exam Questions

Total 203 Questions

Last Updated Exam : 16-Dec-2024

Refer to the exhibit. 


What is a characteristic of the UUID in the service profile presented.


A.

based on the hardware


B.

vendor assigned


C.

unique system generated


D.

allocated from a UUID pool





D.
  

allocated from a UUID pool



In an FCoE environment, for which two sets of data must an interface that implements the PAUSE mechanism always provision sufficient ingress buffer? (Choose two)


A.

frames that were sent with high credit


B.

frames that were processed and transmitted by the transmitter before the PAUSE frame left the sender


C.

frames that were sent on the link but not yet received.


D.

frames that were sent on the link and received.


E.

frames that were processed and transmitted by the transmitter after the PAUSE frame left the sender.





B.
  

frames that were processed and transmitted by the transmitter before the PAUSE frame left the sender



C.
  

frames that were sent on the link but not yet received.



What is an advantage of steaming telemetry over SNMP?


A.

MD-5based authentication on polling


B.

periodic polling of the device status


C.

periodic push-based subscription messages


D.

on-change traps sent to a receiver





C.
  

periodic push-based subscription messages



Refer to the exhibit.

Which backup operation type does not include the Preserve Identities feature?


A.

logical configuration


B.

system configuration


C.

full state


D.

all configuration





C.
  

full state



What is the benefit of adding Cisco HyperFlex Hardware Acceleration Cards to a HyperFlex deployment?


A.

offline encryption acceleration


B.

increased network throughput


C.

GPU acceleration


D.

Increased compression efficiency





D.
  

Increased compression efficiency



Which action must be performed before renumbering a Cisco UCS chassis?


A.

Move the chassis to new ports on fibric interconnect.


B.

Re-acknowledge the chassis.


C.

Decommission the chassis.


D.

Run the shut and no shut command on the connected ports.





C.
  

Decommission the chassis.



An engineer is running an ACI fabric, has VMM integration with VMware vCenter, and wants to enable microsegmentation based on vCenter VM attributes. Which statement about microsegmentation is true?


A.

ACI does not support microsegmentation based on vCenter VM attributes. You should use network attributes for mircosegmentation.


B.

An ACI microsegmented EPG automatically creates a port group with a private VLAN configured on a VMware vCenter distributed virtual switch.


C.

When enabled, microsegmentation performs distributed switching and routing on the ESXi hosts.


D.

Microsegmentation is supported only using AVE or AVS.





B.
  

An ACI microsegmented EPG automatically creates a port group with a private VLAN configured on a VMware vCenter distributed virtual switch.



Refer to the exhibit.

An engineer configures FCIP on a Cisco MDS 9000 Series switch. What is the result of implementing the configuration?


A.

The switch attempts to make two TCP connections


B.

Compression is performed by using hardware


C.

Mode2 is enabled by default.


D.

Compression is performed by using software





B.
  

Compression is performed by using hardware



An engineer is implementing OTV on a transport that supports multicast. The solution needs to meet the
following requirements:
• Establish adjacency to the remote peer by using multicast.
• Enable OTV advertisements for VLAN 100 to the other site.
Which two commands should be configured to meet these requirements? (Choose two.)


A.

otv site-vlan 100


B.

otv data-group 232.2.2.0/28


C.

otv use-adjacency-server 172.27.255.94


D.

otv extend-vlan 100


E.

otv control-group 232.1.1.1





B.
  

otv data-group 232.2.2.0/28



E.
  

otv control-group 232.1.1.1



Which mroute state is created when Bidirectional PIM is deployed at a site?


A.

MVPN Type-6


B.

*,G


C.

MVPN Type-7


D.

S,G





B.
  

*,G




Page 4 out of 21 Pages
Previous