Drag and drop the technologies from the left onto the correct definitions on the right.

A customer of an ISP requests support to setup a BGP routing policy. Which BGP attribute
should be configured to choose specific BGP speakers as preferred exit
points for the customer AS?

A.

highest local preference outbound

B.

lowest local preference inbound

C.

highest local preference inbound

D.

lowest multi-exit discriminator

Refer to the exhibit.

An engineer needs to implement this QoS policy on customer's network due to ongoing
slow network issues. What will be the effect on the network when the engineer implements
this configuration?

A.

Traffic that is identified in the ciscotest class map will be remarked from IP precedence 1
to DSCP AF11 when it enters the pos0/2/0/0 interface.

B.

Traffic that is identified in the ciscopolicy class map will be marked with IP precedence 1
when it enters the pos0/2/0/0 interface.

C.

Traffic that is identified in the ciscopolicy class map will be remarked from IP
precedence 1 to DSCP AF11 when it exits the pos0/2/0/0 interface.

D.

Traffic that is identified in the ciscotest class map will be marked with IP precedence 1
when it exits the poso/2/0/0 interface.

Refer to the exhibit.

While troubleshooting a connectivity issue on router R2, a network engineer with an
employee id:3876.13.497 notices that although it detects three OSPF links from R1, the
OSPF prefixes are missing from the routing table. What is the reason for the problem?

A.

The serial interfaces have different MTUs

B.

Both loopback interfaces on R1 are configured as stub

C.

The R2 Serial 1/0 interface is configured with an IP address, but the R1 Serial R1 Serial
1/0 interface in unnumbered.

D.

The subnet masks on the serial interfaces are mismatched.

Which additional feature does MPLS DiffServ tunneling support?

A.

matching EXP and DSCP values

B.

nteraction between MPLS and IGP

C.

using GRE tunnels to hide markings

D.

PHB layer management

Refer to the exhibit:

Which statement about this configuration is true"?

A.

It requires an explicit Cisco MPLS TE path to be configured for the tunnel to run

B.

It requires OSPF to also be running to have optimized Cisco MPLS TE tunnels

C.

It requires a dynamic Cisco MPLS TE path to be configured for the tunnel to run

D.

It is the configuration for the head-end router of a Cisco MPLS TE tunnel with segment
routing

Which statement describes the advantage of a Multi-Layer control plane?

A.

It automatically provisions monitors, and manages traffic across Layer 0 to Layer 3

B.

It minimizes human error configuring converged networks

C.

It supports dynamic wavelength restoration in Layer 0

D.

It provides multivendor configuration capabilities for Layer 3 to Layer 1

Refer to the exhibit.

A network engineer is configuring customer edge routers to finalize a L2VPN over MPLS
deployment Assume that the AToM L2VPN service that connects the two CEs is configured
correctly on the service provider network Which action causes the solution to fail?

A.

A loopback with a /32 IP address has not been used

B.

OSPF does not work with L2VPN services

C.

The x connect statement has not been defined

D.

The routing protocol network types are not compatible

Refer to the exhibit:

Which three outcomes occur if the prefix list is added to the neighbor? (Choose three)

A.

192.168 0.0/19 is denied.

B.

192.168 0.0/17 is denied.

C.

192.168 0.0/17 is permitted

D.

192.168.0.0/16 is denied

E.

192.168 0.0/16 is permitted

F.

192.168 0.0/19 is permitted

Refer to the exhibit:

Which configuration prevents the OSPF neighbor from establishing?

A.

mtu

B.

duplex

C.

network statement

D.

default-metric