Topic 1: Exam Pool A
desc about topic
When configuring IPv6 on an interface, which two IPv6 multicast groups are joined? (Choose two)
A.
2000::/3
B.
2002::5
C.
FC00::/7
D.
FF02::1
E.
FF02::2
FF02::1
FF02::2
Which technology is used to improve web traffic performance by proxy caching?
A.
WSA
B.
Firepower
C.
ASA
D.
FireSIGHT
WSA
Refer to the exhibit
A.
Switch 1
B.
Switch 2
C.
Switch 3
D.
Switch 4
Switch 2
Which resource is able to be shared among virtual machines deployed on the same physical server?
A.
disk
B.
applications
C.
VM configuration file
D.
operating system
VM configuration file
What are two similarities between UTP Cat 5e and Cat 6a cabling? (Choose two.)
A.
A. Both operate at a frequency of 500 MHz.
B.
Both support runs of up to 55 meters.
C.
Both support runs of up to 100 meters.
D.
Both support speeds of at least 1 Gigabit.
E.
Both support speeds up to 10 Gigabit.
Both support runs of up to 100 meters.
Both support speeds of at least 1 Gigabit.
What is a DHCP client?
A.
a host that is configured to request an IP address automatically
B.
a server that dynamically assigns IP addresses to hosts
C.
a workstation that requests a domain name associated with its IP address
D.
a rooter that statically assigns IP addresses to hosts
a host that is configured to request an IP address automatically
What causes a port to be placed in the err-disabled state?
A.
latency
B.
port security violation
C.
shutdown command issued on the port
D.
nothing plugged into the port
port security violation
Explanation: This mode is the default violation mode; when in this mode, the switch will
automatically force the switchport into an error disabled (err-disable) state when a violation
occurs. While in this state, the switchport forwards no traffic. The switchport can be brought
out of this error disabled state by issuing the errdisable recovery cause CLI command or by
disabling and reenabling the switchport.
Which technology allows for multiple operating systems to be run on a single host
computer?
A.
virtual routing and forwarding
B.
network port ID visualization
C.
virtual device contexts
D.
server visualization
server visualization
Refer to the exhibit.
When PC-A sends traffic to PC-B, which network component is in charge of receiving the
packet from PC-A verifying the IP addresses, and forwarding the packet to PC-B?
A.
Layer 2 switch
B.
Router
C.
Load balancer
D.
firewall
Router
Explanation: PC-A and PC-B are not in the same network. Switches send traffic in layer 2
and within the same VLA while routers route traffic to different subnet and at layer 3.
What is a network appliance that checks the state of a packet to determine whether the packet is legitimate?
A.
Layer 2 switch
B.
load balancer
C.
firewall
D.
LAN controller
firewall
| Page 13 out of 87 Pages |
| Previous |
Copyright © - All Rights Reserved